49 www.plastidip.co.uk Sales +44 (0) 1730 823 823 After cleaning with Prep Cleaner: n Dry the component completely n Shake the can for 60 seconds before application n Apply ColorBond adhesion promoter n Apply heat (recommend 10 minutes at 60°C–121°C / 140–250°F) HOW TO USE COLORBOND CAR INTERIOR PAINT ColorBond Leather, Vinyl & Hard Plastic Refinisher is automotive and marine interior paint Designed for easy use, follow these basic steps to rejuvenate your vehicle’s interior: For best results, remove the component n Carry out any repairs needed n Thoroughly clean all surfaces as detailed above n Ensure surface is dry n Shake can for two minutes n Apply a light mist coat 12” from the surface n Multiple coats may be needed n Allow two minute drying time between coats n Bonds in 10 minutes WHAT IS THE COVERAGE OF THE AEROSOLS? While coverage may vary depending on the colour selection and substrate to be painted, a conservative estimate is 8ft² per can While ColorBond penetrates the substrate, it will not fill cracks or tears Therefore, any repair should be performed before painting Primer for all coatings DESCRIPTION Plasti Dip PRIMER is an air-dried, acrylic primer specifically developed to increase adhesion of Plasti Dip and HCF to NONABSORBENT surfaces, by up to 400% PRIMER can be sprayed, dipped or brushed and offers fast set up time with a high coverage rate Typically applied in one coat, only extreme corrosion and abrasion require a second or third coat, eliminating extensive preparation for most applications Plasti Dip PRIMER is recommended on most surfaces, especially metal For best results apply over PRIMER as soon as it is dry to the touch Plasti Dip PRIMER is not recommended for use as protective coating on its own Plasti Dip PRIMER is available in either grey or clear colour options SURFACE PREPARATION Mix well before use All surfaces to be coated must be free of any oils, loose rust, dirt or dust, and thoroughly dry A sandblasted or rough surface allows for best adhesion of Plasti Dip PRIMER USE ADEQUATE VENTILATION SPRAYING Pressure pot/conventional spray equipment may be used Dilute with recommended Thinners as needed Gently mix before spraying Apply wet overlapping coats, holding gun 6"–12” from surface, using a 4”–6” pattern Allow 30 minutes drying time before applying additional coats to desired thickness or before applying Plasti Dip DIPPING Gently mix before each use Do not introduce air bubbles Insert 1” every 5 seconds Remove at same rate Allow 20–40 minutes (dry to touch) drying time before applying additional coats to desired thickness or before applying Plasti Dip BRUSHING Gently mix before each use Apply wet, overlapping coats using a soft natural bristle brush Allow 30 minutes drying time before applying additional coats to desired thickness or before applying Plasti Dip HINTS A dry film thickness of 1–3 mls is recommended for best results Avoid excessive air movement, heat or humidity If these conditions exist, then thin down to 10–20% using Plasti Dip Thinners Always use proper ventilation and protection TECH DATA on page 52 DO NOT USE PRIMER ON SURFACES IF YOU WISH TO REMOVE PLASTI DIP MULTIPURPOSE COATING AT A FUTURE STAGE AS PRIMER WILL MAKE IT PERMANENT BEST PRICES ON OUR WEBSITE https://tinyurl. com/9xfzyzmw
RkJQdWJsaXNoZXIy NTIxMTY=