48 www.plastidip.co.uk Sales +44 (0) 1730 823 823 HCF Acrylic Hard Coat HCF is a water-based product that MUST be stored above Freezing and applied at room temperature, ideally above 16°C Mix well before use for best results use an electric paddle mixer, especially before spraying All surfaces to be coated must be free of oils, dirt, wax and loose paint or rust, and thoroughly dry A sandblasted or rough surface improves adhesion Use Plasti Dip PRIMER for best results on smooth or nonabsorbent surfaces For a professional fine finish HCF should be filtered first, especially when spraying SPRAYING Pressure pot/conventional sprayer may be used Gently mix before spraying Apply wet, overlapping coats, holding gun 150–300 mm from surface, using a 100–150 mm pattern Allow to completely dry before applying additional coats to desired thickness For spray application of HCF, add up to 10% distilled water ONLY for dilution DIPPING Gently mix before each use Do not introduce air bubbles Allow the paint to stand for 2-3 hours for trapped air to disperse Insert item 25 mm every 5 seconds Remove at the same rate Allow to completely dry before applying additional coats to desired thickness BRUSH ROLLER Gently mix before each use Apply wet overlapping coats using a foam brush, pad or roller Allow to completely dry before applying additional coats to desired thickness HINTS. For storage or dip tank containers, use only poly or galvanised steel A dry film thickness of 6-8 mls* is recommended for best results Allow overnight drying whenever possible For speed drying, mild heat (35°C–43°C / 95°F–110°F) and air flow may be used Do not stack or store parts in contact with each other if not fully cured Avoid excessive air movement, heat or dampness Being waterbased, please avoid applying in cold, damp or humid conditions, otherwise allow longer drying times and protect from the elements Always use proper ventilation and use proper protection Do not allow it to freeze in storage * 1 mls = 0001 inch or 00254 millimeters ColorBond ColorBond paints look great! They are known for being easy to apply, durable and long-lasting. To obtain the best results, proper paint preparation is important. For all surfaces we recommend using ColorBond Prep Cleaner to remove dirt, dust, and oil, as well as silicones and conditioners that could inhibit the paint from bonding. USING COLORBOND PREP CLEANER; n Clean the surface thoroughly n Apply ColorBond prep cleaner with clean, tack-free cloth n Remove excess cleaner n Dries in five minutes When refinishing hard trim or metal such as door panels or pillars we recommend sanding with 1200 grit wet sandpaper, washing with Prep Cleaner, and then applying a thin coat of ColorBond Adhesion Promoter This will improve the bond between the surface and the paint Of note, while it isn’t necessary to sand soft trim such as vinyl, it is recommended to lightly sand leather Adhesion Promoter does not need to be used on soft trim and leather ColorBond Adhesion Promoter prevents flaking, cracking and peeling when painting a vehicle’s interior Created to improve the bond between paint and today’s auto plastics like PPO & TPO, our Adhesion Promoter is easy to use (see guide on our website https://www.plastidip.co.uk on how to identify different plastics) HINTS, TIPS AND FAQS FOR APPLYING PRODUCTS
RkJQdWJsaXNoZXIy NTIxMTY=