47 www.plastidip.co.uk Sales +44 (0) 1730 823 823 Aerosols Shake well before and during use Test spray pattern on sample piece prior to application In cold conditions, place aerosol in warm water (approximately 21°C) for 10-15 minutes before use Invert can and spray to clear nozzle after each activation Refer to aerosol can for full instructions BRUSHING You can dilute with Plasti Dip Thinners up to 25% for this method Gently mix before each use without introducing air bubbles Apply wet overlapping coats using a soft, natural bristle brush Allow 30 minutes drying time (touch dry) between coats to the desired thickness (Refer to the Best Practice section below) On completion allow 4 hours drying time per coat before use and overnight drying if possible (Refer to the Best Practice section below) Clean up using Plasti Dip Thinners General You can access Manufacturers Safety Data Sheet and Technical Data Sheet through our website www.plastidip.co.uk BEST PRACTICE In common with all manufacturer’s advice, we recommend testing on a small inconspicuous area first to ensure suitability Base colours can alter the final shade n For a professional fine finish, Plasti Dip liquid should be filtered first n The thicker the final coating, the easier it is to remove in the future should you wish, and it will provide a more durable finish n For other projects, a minimum of 2-4 coats is recommended depending on application method and coverage requirement n Layers are touch dry and re-coatable in 30-45 minutes at 16-22°C and totally cured/dry 24-48 hours depending on temperature Increase drying times in colder conditions n Plasti Dip Primer is an adhesion promoter Only use a primer to increase adhesion if you require a permanent coating For permanent application, keying the surface with fine grit paper will improve adhesion if required n For extra protection of your investment and ease of cleaning, we recommend using Dip Care Sealant over the final coating BLAZE COLOURS n Flourescent colours are best applied over a white Plasti Dip base coat They are much less likely to fade if a small amount of Pro FX Pigment is added If you have any concerns about the correct products or procedures for your project, please contact us on the details on the left side of even pages For vehicles we recommend 7 coats WATCH PLASTI DIP BEING REMOVED FROM A VEHICLE! v Continued on page 48
RkJQdWJsaXNoZXIy NTIxMTY=